7757-K122 External 24V 150W Switching Power Adapter

Introduction

This kit provides a 24V 150W Power Supply for NCR Columbus 900 terminals.

Power Supply AC requirements are listed in the table below.

	Voltage Range	Max. Current	Frequency Range
AC Input	100-240V	2.0 A	50-60 Hz

Note:  AC Power Cords are not included in this kit.

Kit Contents

 

 

External 24V 150W Switching Power Adapter(7757-K122)
	Part Number	Description
1	497-0510669	Power Supply 150W 24V, 6-Pin DC, C13 AC, DOE 6

Installation Procedure

1.Tilt the Display backward.

2.Slide the Front Cover upward to remove it from the stand.

3.From the rear side of the terminal, insert the PSU DC cable and route the cable towards the front side of the stand.

4.Connect the DC Cable to the DC IN connector of the I/O Panel.

5.Install the Front Cover to the stand.
Insert the two tabs of the cover to the slots on the base of the stand and then rotate the upper part of the cover until it snaps, secured to the stand.

6.Connect the AC Power Cord to the Power Supply.

Note:  The AC Power Cord is not included in this kit.